MLK-14707 fsl_esdhc: Fix eMMC 1.8v setting issue

Current USDHC driver will reset VSELECT to 0 (3.3v) during mmc init,
then set to 1 for 1.8v eMMC I/O. When booting from eMMC, since ROM has
already set VSELECT to 1.8v before running the u-boot. This reset in
USDHC driver causes a short 2.2v pulse on CMD pin.

Fix this issue by not reset VSELECT to 0 when 1.8v flag is set.

Signed-off-by: Ye Li <ye.li@nxp.com>
(cherry picked from commit f01ebfda)

drivers/mmc/fsl_esdhc.c

@@ -611,7 +611,10 @@ static int esdhc_init(struct mmc *mmc)
 	esdhc_write32(&regs->clktunectrlstatus, 0x0);
 
 	/* Put VEND_SPEC to default value */
-	esdhc_write32(&regs->vendorspec, VENDORSPEC_INIT);
+	if (cfg->vs18_enable)
+		esdhc_write32(&regs->vendorspec, (VENDORSPEC_INIT | ESDHC_VENDORSPEC_VSELECT));
+	else
+		esdhc_write32(&regs->vendorspec, VENDORSPEC_INIT);
 
 	/* Disable DLL_CTRL delay line */
 	esdhc_write32(&regs->dllctrl, 0x0);
@@ -640,9 +643,6 @@ static int esdhc_init(struct mmc *mmc)
 	/* Set timout to the maximum value */
 	esdhc_clrsetbits32(&regs->sysctl, SYSCTL_TIMEOUT_MASK, 14 << 16);
 
-	if (cfg->vs18_enable)
-		esdhc_setbits32(&regs->vendorspec, ESDHC_VENDORSPEC_VSELECT);
-
 	return 0;
 }