Both CFG_PCISPEED_66 and CFG_IPBSPEED_133 are misnamed, as defining
them does not cause PCI or IPB clocks to run at the specified speed.
Instead, they configure divisors used to calculate said clocks. This
patch renames the defines according to their real function.

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>
Acked-by: Bartlomiej Sieka <tur@semihalf.com>

Signed-off-by: Jan Wrobel <wrr@semihalf.com>
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Acked-by: Bartlomiej Sieka <tur@semihalf.com>

definition.

environment.

eliminates networking problems in Linux (timeouts).

to allow booting of FDT-expecting kernels.

current PHY initalization code (tftp timeouts all the time). This commit
temporarily disables PHY initalization sequence to make the networking
operational, until a fix is found.

currently sectors 0-3. Sector 3 does not need to be protected, though
(U-boot occupies sectors 0-1 and the environment sector 2). This commit
fixes this, i.e., only sectors 0-2 are protected.

"mii device" results in "Unexpected exception"). Fixing this properly
requires some clean-up in the FEC drivers infrastructure for ColdFire, so
this commit disables MII commads for now.

Identification Register (CIR).

Signed-off-by: Heiko Schocher <hs@denx.de>

             if you must swap the bytes between reading/writing.
             (Needed for the SC3 board)

Signed-off-by: Heiko Schocher <hs@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

             The EBC Configuration Register is now by CFG_EBC_CFG definable
             Added JFFS2 support for the SC3 board.

Signed-off-by: Heiko Schocher <hs@denx.de>

Signed-off-by: Stefan Roese <sr@denx.de>

Some code cleanup.

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Heiko Schocher <hs@denx.de>

Haiying Wang's modification to the reset command was broken, undo it.

Signed-off-by: Wolfgang Denk <wd@denx.de>

Also display enabled/disabled RAID 6 support for 440SP/440SPe PPC's.

Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.

Also the EBC initialising is now done via defines in the board config
file.

Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.

Also the EBC initialising is now done via defines in the board config
file.

Signed-off-by: Stefan Roese <sr@denx.de>

Now the board revision and the current PCI bus speed are printed after
the board message.

Signed-off-by: Stefan Roese <sr@denx.de>