Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

This fixes the cluster size tests in the FAT32 file system.
The current implementation of VFAT support doesn't work if the
referred cluster has an offset > 16bit representation, causing
"fatload" and "fatls" commands etc. to fail.

Signed-off-by: michael trimarchi <trimarchi@gandalf.sssup.it>

Signed-off-by: Wolfgang Denk <wd@denx.de>

The 405EZ only supports 512 bytes of rx-/tx-fifo EMAC sizes. But
currently 4k/2k is configured. This patch fixes this issue.

Thanks to Thomas Kindler <tkindler@lenord.de> for pointing this out.

Signed-off-by: Stefan Roese <sr@denx.de>

Fix alignment fault on ARM when running modules.  With out an explicit
linker file gcc4.2.1 will half word align __bss_start's value.  The word
dereference will crash hello_world.

signed-off-by Richard Woodruff <r-woodruff2@ti.com>

The ext2 aligned process will corrupt the key
data struct, the patch fix this.

Signed-off-by: Dave Liu <daveliu@freescale.com>

Make sure CDPATH settings cannot interfere.
Update CHANGELOG.

Signed-off-by: Wolfgang Denk <wd@denx.de>

Add cscope build target to generate cscope database for code browsing.

Signed-off-by: Li Yang <leoli@freescale.com>

erratum 5.6 states the autoneg completion bit is functional only if the
autoneg bit is asserted.

This fixes any secondarily-issued networking commands on non-gigabit
links on the mpc8360 mds board.

Signed-off-by: Kim Phillips <kim.phillips@freescale.com>

Adds PCI support for MPC5121

Tested with drivers/net/rtl8139.c

Support is conditional since PCI on old silicon does not work.

ads5121_PCI_config turns on PCI

In this version, condition compilation of PCI code has been moved
from ifdef in board/ads5121/pci.c to board/ads5121/Makefile as
suggested by Jean-Christophe PLAGNIOL-VILLARD

Signed-off-by: John Rigby <jrigby@freescale.com>

Fix warnings while compilation with new gcc in eldk-4.2

Signed-off-by: Anatolij Gustschin <agust@denx.de>

U-Boot crashes in the net loop if CONFIG_4xx_DCACHE is
enabled. To reproduce the problem ensure that 'ethrotate'
environment variable isn't set to "no" and then run
"tftp 200000 not_existent_file".
This patch tries to fix the issue.

Signed-off-by: Anatolij Gustschin <agust@denx.de>

Currently (since commit b2e2142c) u-boot crashes on
sequoia board while SPR test if CONFIG_4xx_DCACHE is
enabled. This patch disables the cache while SPR test.

Signed-off-by: Anatolij Gustschin <agust@denx.de>

Call fdt_fixup_memory() on the boards TQM5200, TQM5200_B, TQM5200S,
TB5200 and TB5200_B to fixup the /memory node with the memory values
detected by U-Boot.

Signed-off-by: Martin Krause <martin.krause@tqs.de>

Conflicts:

	include/asm-arm/arch-imx/imx-regs.h

Signed-off-by: Wolfgang Denk <wd@denx.de>

Call fdt_fixup_memory() on the boards TQM5200, TQM5200_B, TQM5200S,
TB5200 and TB5200_B to fixup the /memory node with the memory values
detected by U-Boot.

Signed-off-by: Martin Krause <martin.krause@tqs.de>

This patch fixes a bug in the SDRAM initialization code for the
TQM5200. The hi_addr bit is now set correctly. Without this patch
the hi_addr bit is always set to 1, if the second SDRAM bank is
not populated.

For other MPC5200 boards a correspondig patch has already been applied
some time ago, see commit a6310928.

Signed-off-by: Martin Krause <martin.krause@tqs.de>
--
Forget the first patch please. I confused flash with SDRAM in
the comment ...

"pointer targets in assignment differ in signedness"

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Sync register definitions with linux

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

- actua1:
	actux1.c: In function 'checkboard':
	actux1.c:92: warning: unused variable 'revision'

- actua2:
	actux2.c: In function 'checkboard':
	actux2.c:100: warning: unused variable 's'
	actux2.c:99: warning: unused variable 'revision'
	actux2.c: In function 'reset_phy':
	actux2.c:130: warning: unused variable 'i'

- actua3:
	actux3.c: In function 'checkboard':
	actux3.c:114: warning: unused variable 'revision'

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

The previous patch was lacking of i386, microblaze, nios and nios2. This
patch tries to fix them.

Signed-off-by: Shinya Kuribayashi <skuribay@ruby.dti.ne.jp>

There is no reason to icbi when invalidating the temporary stack in
the d-cache.  Its impossible on e500 to have the i-cache contain
any addresses in the temp stack and it can be problematic in generating
transactions on the bus to non-valid addresses.

Signed-off-by: Kumar Gala <galak@kernel.crashing.org>

The source vector for the ECM was being set to 2,
but that's what the source vector for DDR was being
set to.  Change it to 1.

Signed-off-by: Andy Fleming <afleming@freescale.com>

Commit 0db37dc2...  (and some others) changed the INIT_RAM TLB
mappings to be unguarded.  This collided with an existing "bug"
where the mappings for the INIT_RAM were being kept around.
This meant that speculative loads to those addresses were
succeeding in the TLB, and going out to the bus, where they
were causing an exception (there's nothing at that address). The
Flash code was coincidentally causing such a speculative load.
Rather than go back to mapping the INIT RAM as guarded, we fix
it so that the entries for the INIT_RAM are invalidated.  Thus
the speculative loads will fail in the TLB, and have no effect.

Signed-off-by: Andy Fleming <afleming@freescale.com>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Back in commit a551cee9
(86xx: Fix GUR PCI config registers properly), we should have
changed the MPC86xx_PORBMSR_HA and MPC86xx_PORDEVSR_IO_SEL
symbols in the sbc8641d board as well.  Fix this oversight.

Signed-off-by: Jon Loeliger <jdl@freescale.com>

Don't include testdram() on NAND-booting target acadia_nand. This saves
a few bytes and makes the target build clean again.

Signed-off-by: Stefan Roese <sr@denx.de>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Sync registers definition with linux

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

- actua1:
	actux1.c: In function 'checkboard':
	actux1.c:92: warning: unused variable 'revision'

- actua2:
	actux2.c: In function 'checkboard':
	actux2.c:100: warning: unused variable 's'
	actux2.c:99: warning: unused variable 'revision'
	actux2.c: In function 'reset_phy':
	actux2.c:130: warning: unused variable 'i'

- actua3:
	actux3.c: In function 'checkboard':
	actux3.c:114: warning: unused variable 'revision'

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Signed-off-by: Wolfgang Denk <wd@denx.de>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

----------------------------------------------------------------
Olaf Hering [Wed, 17 Oct 2007 06:27:13 +0000 (23:27 -0700)]

Remove the __STRICT_ANSI__ check from the __u64/__s64 declaration on
32bit targets.

GCC can be made to warn about usage of long long types with ISO C90
(-ansi), but only with -pedantic.  You can write this in a way that even
then it doesn't cause warnings, namely by:

#ifdef __GNUC__
__extension__ typedef __signed__ long long __s64;
__extension__ typedef unsigned long long __u64;
#endif

The __extension__ keyword in front of this switches off any pedantic
warnings for this expression.

Signed-off-by: Olaf Hering <olh@suse.de>
Cc: <linux-arch@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
----------------------------------------------------------------

Signed-off-by: Shinya Kuribayashi <skuribay@ruby.dti.ne.jp>

This will reduce the build time.

Signed-off-by: Shinya Kuribayashi <skuribay@ruby.dti.ne.jp>