Blackfin: back out status_led.h stubs

When boards define CONFIG_BOARD_SPECIFIC_LED, the common led definitions
are OK for Blackfin boards.  So switch the few boards using these over to
the common code.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

include/configs/bf526-ezbrd.h

@@ -161,12 +161,6 @@
 /* #define CONFIG_STATUS_LED */
 #ifdef CONFIG_STATUS_LED
 #define CONFIG_BOARD_SPECIFIC_LED
-#ifndef __ASSEMBLY__
-typedef unsigned int led_id_t;
-void __led_init(led_id_t mask, int state);
-void __led_set(led_id_t mask, int state);
-void __led_toggle(led_id_t mask);
-#endif
 /* use LED0 to indicate booting/alive */
 #define STATUS_LED_BOOT 0
 #define STATUS_LED_BIT 1

include/configs/bf533-stamp.h

@@ -231,12 +231,6 @@
 /* #define CONFIG_STATUS_LED */
 #ifdef CONFIG_STATUS_LED
 #define CONFIG_BOARD_SPECIFIC_LED
-#ifndef __ASSEMBLY__
-typedef unsigned int led_id_t;
-void __led_init(led_id_t mask, int state);
-void __led_set(led_id_t mask, int state);
-void __led_toggle(led_id_t mask);
-#endif
 /* use LED1 to indicate booting/alive */
 #define STATUS_LED_BOOT 0
 #define STATUS_LED_BIT 1

include/status_led.h

@@ -346,9 +346,6 @@ void status_led_set  (int led, int state);
 #elif defined(CONFIG_NIOS2)
 /* XXX empty just to avoid the error */
 /************************************************************************/
-#elif defined(CONFIG_BLACKFIN)
-/* XXX empty just to avoid the error */
-/************************************************************************/
 #elif defined(CONFIG_V38B)
 
 # define STATUS_LED_BIT		0x0010			/* Timer7 GPIO */