mpc52xx, digsy_mtc_rev5: Fix Linux crash, if no Flash in bank 2

If no Flash is connected to cs1, Linux crashes, because
reg entries are not correct adapted.

Following fix is needed:
- swap base addresses in CONFIG_SYS_FLASH_BANKS_LIST, as
  flash bank 1 is on chipselect 0 and flash bank 2 on
  chipselect 1
- call fdt_fixup_nor_flash_size() from ft_board_setup()

Signed-off-by: Heiko Schocher <hs@denx.de>
cc: Wolfgang Denk <hs@denx.de>
cc: Werner Pfister <Pfister_Werner@intercontrol.de>
cc: Detlev Zundel <dzu@denx.de>

board/digsy_mtc/digsy_mtc.c

@@ -46,6 +46,7 @@
 #include "is42s16800a-7t.h"
 #endif
 #include <libfdt.h>
+#include <fdt_support.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 
@@ -415,6 +416,10 @@ void ft_board_setup(void *blob, bd_t *bd)
 	ft_delete_node(blob, "mc,rv3029c2");
 #endif
 #if defined(CONFIG_SYS_UPDATE_FLASH_SIZE)
+#ifdef CONFIG_FDT_FIXUP_NOR_FLASH_SIZE
+	/* Update reg property in all nor flash nodes too */
+	fdt_fixup_nor_flash_size(blob);
+#endif
 	ft_adapt_flash_base(blob);
 #endif
 }

include/configs/digsy_mtc.h

@@ -268,8 +268,8 @@
 #define CONFIG_SYS_FLASH_BASE		0xFE000000
 #define CONFIG_SYS_FLASH_BASE_CS1	0xFC000000
 #define CONFIG_SYS_MAX_FLASH_BANKS	2
-#define CONFIG_SYS_FLASH_BANKS_LIST	{ CONFIG_SYS_FLASH_BASE_CS1, \
-					CONFIG_SYS_FLASH_BASE}
+#define CONFIG_SYS_FLASH_BANKS_LIST	{ CONFIG_SYS_FLASH_BASE, \
+					CONFIG_SYS_FLASH_BASE_CS1}
 #define CONFIG_SYS_UPDATE_FLASH_SIZE
 #define CONFIG_FDT_FIXUP_NOR_FLASH_SIZE
 #else